Burkert 8025 Notice D'utilisation page 68

3 INSTALLATION
3.3.6 Connecting the flow rate sensor to controller 8025 Batch in
separate versions
Connect the remote flow rate sensor to the FLOW SENSOR connector of the electronic
board, by respecting the pin assignment according to the output type of the remote
sensor, either sinus output (COIL) or pulse output (NPN). First of all, correctly configure
both switches on the electronic board (see § 3.3.3).
NC
1 2 3 4 PE
Sensor with a sinus output
NC = Not connected
Shielding of the sensor
cable
BATCH CONTROLLER 8025
NC
1 2 3 4 PE
Sensor with a pulse output (NPN)
E-18-
Pulse NPN
V-
V+
Shielding of the sensor cable