1
General safety information
Meaning of the symbols used in the operating and installation instructions:
WARNING:
The possibility of serious or even fatal injury exists in the event of non-observance.
CAUTION:
The possibility of slight to moderate injury or material damage exists in the event of non-observance.
TIP:
Gives tips for use and useful information.
Store these instructions for installation and use carefully near to the control unit in order to be able to
refer to safety tips and operating information at any time.
•
Improper assembly can constitute a fi re risk!
•
Electrical connection may only be executed by qualifi ed experts.
•
The wiring diagram must be complied with during connection.
•
Before the control element is commissioned, it must be verifi ed that all connections are fi rmly connected.
•
This device is not intended for use by persons (including children) with limited physical, sensory or mental
capacities or a lack of experience and/or knowledge, unless they are supervised by a person responsible for
their safety.
•
Children should be supervised to ensure that they do not play with the device.
•
The device is not appropriate for the direct control of sauna heating devices. Fire hazard.
•
Keep these instructions for assembly and use carefully in proximity to the control unit in order to be able to
refer to safety tips and important information at any time.
•
Also heed the special safety tips in the individual chapters.
•
If specifi c problems occur which are not suffi ciently dealt with in these instructions for use, please contact
your supplier for the sake of your own safety.
•
Unauthorised modifi cations or alterations to this sauna control unit are not permitted for safety reasons.
•
Read these instructions for installation and use carefully before assembling the device. This will enable you
to make use of all benefi ts which the device has to offer and prevent damage.
•
The operating instructions for the combinable devices of the wave.com4 series must be heeded and
constitute part of these instructions for use.
•
The IS2 infrared control unit may only be connected under strict compliance with these instructions. You
must only use the original cable supplied and original components. The standards (wire cross-section,
insulation, temperature class, etc.) are only safely complied with when these cables are used.
•
Subject to technical changes.
WE DO IT FIRST.
Instructions for installation and use
P. 3/14
EN