Important Information For Your Safety; Intended Use - Sentiotec infrabox basic Instructions De Montage Et Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Instructions for installation and use

2. Important information for your safety

The Infrabox Basic infrared controller has been produced in ac-
cordance with the safety regulations applicable for technical units.
However, hazards may occur during use. Therefore adhere to the
following safety information and the specific warning notices in
the individual chapters. Also observe the safety information for the
devices connected.

2.1. Intended use

The Infrabox Basic infra controller is used exclusively for control-
ling and operating the light/fan and infrared heater/infrared plate.
The Infrabox infrared controller is suitable for use with
intrinsically safe infrared heaters and infrared plates.
If no intrinsically safe products are being used, a safety
temperature limiter must be connected.
Observe the instructions for this in the operating instruction manual.
The Infrabox Basic infrared controller may only be used for control-
ling a maximum capacity of 3.5 kW.
Overview of the operating modes:
Switchable: up to 3.5 kW
Half-wave control (dimmable): up to 1.3 kW
Leading edge phase control (dimmable): up to 350 W
p. 5/32
EN

Publicité

Table des Matières
loading

Table des Matières