Use As Intended; Installation Instructions - Only For Experts; Preparation Of The Surface Mounting - Sentiotec IS1 Instructions De Montage Et Mode D'emploi

2

Use as intended

The IS2 infrared control unit is only suitable for use with inherently safe infrared radiators and infrared plates.
Also heed the instructions in the respective manual.
Before commissioning the control unit, the operational state of the cabin must be verifi ed. This applies in parti-
cular if the control unit will be started via remote start. See also the conditions in EN60335 -2-53
Suitable infrared radiators:
DIR-350-R, WIR-350-R, DIR-500-R, WIR-500-R, DIR-750-R, WIR-750-R, DIR-1300-R, WIR-1300-R
ECO-350-R, ECO-350-G, ECO-500-R, ECO-500-G, ECO-750-R
O-IRC-C, O-IRC-W
Suitable infrared plates – only in conjunction with optional fi lm sensor XXXXX:
IR-WP-175, IR-WP-100, IR-WP-390, IR-WP-510
IR-WPHL-510, IR-WPHL-100, IR-WPHL-390, IR-WPHL-175
3 Installation instructions – only for experts
The control unit can be surface-mounted, see Chapter 3.1, or countersunk, see Chapter 3.2.
3.1 Preparation of the surface-mounting
In order to surface mount the control, cable lead-throughs must be provided in the cabin wall.
The positions can be found in the fi gure below.
49
17,5
34
49
65
80,5
Fig. 1 positions of cable outfl ows
aerial view
WE DO IT FIRST.
Instructions for installation and use
- Sensor cable opening;
if necessary, these can
also be guided down-
wards through the cable
shaft provided for in the
housing .
Caution: if the cables
need to be guided
downwards via the
cable shaft 7,it must be
ensured that the sensor
cables are equipped
with additional protecti-
ve insulation
- Cable
- Radiator outfl ow 1
- Radiator outfl ow 2
- Fan outfl ow
- Light outfl ow
7
2 3 4 5 6
Fig. 2 Cable outfl ows
Caution - rear view
P. 4/14
1