Inner Lining - Touratech AVENTURO MOD Manuel D'utilisation

C. THE HELMET

14. INNER LINING

The replaceable inner lining of the AVENTURO Mod is washable and
ensures both an excellent fit and improved ventilation of the helmet.
The high-comfort cheek pads ensure that the helmet fits comfortably
around the cheeks, and the headband pad provides an optimal fit all
around the head. The head pad sits comfortably on the head without
covering the ventilation channels.
The internal lining consists of skin-friendly materials throughout, par-
ticularly in areas that come in contact with the head. These are a soft,
breathable COOLMAX material that transports heat and moisture very
®
well, a special noise-reducing Polygene
properties and a sweat-absorbing Interpower
REMOVING THE LINING
1. Undo the snaps on the front straps
of the neck collar and pull the neck
collar out of the mounting by pulling
strongly inwards.
2. Undo the two rear snaps of the
cheek pads as well as rear crown
liner retention flap button.
78
material with antibacterial
®
material.
®
3. Pull the plastic bar out of the
mounting and remove the crown
liner.
MOUNTING THE CROWN LINER
The sewn-in plastic bar on the forehead section and the retention flaps
in the neck area are used as mounting assists.
1. Push the plastic bar piece by piece
below the notches on the plastic bar
affixed to the inner shell.
2. Insert the plastic retention flaps with
round holes over the pins sewn into
the rear section of the cheek pad
and affix them using the red snaps.
EN
79