Touratech AVENTURO MOD Manuel D'utilisation page 34

C. THE HELMET
Caution:
Never ride without making sure that the chinstrap is correctly
fastened and adjusted and properly positioned. If the chinstrap is
not correctly adjusted or fastened, the helmet could be displaced in
the event of an accident.
Caution:
Closing the comfort pad of the chinstrap alone will not provide
adequate protection. The chinstrap must always be fully fastened.
Caution:
Never open the chinstrap while riding.
11. SHIELD
The screen designed in SCHUBERTH's own wind tunnel offers protec-
tion from the sun's rays and from rocks.
ADJUSTING THE SHIELD POSITION
The shield can be fixed into one of three
different positions as required.
1. Move the positioning lever on both
sides toward the bottom.
2. Adjust the shield to the desired
position.
3. Return the positioning lever back to
its starting position.
66
DISASSEMBLY
Turn the bayonet fastenings on both
sides to unlock the shield. Then you can
remove the shield from the mechanism.
ASSEMBLY
Use both hands to guide the snap-in pins
on the shield into the slots provided for
them in the visor mechanism, then close
the bayonet fastening.
Note:
Check that the shield is firmly seated before you next use it.
Tip:
You can also use the helmet without the shield.
The fastening pins included in the scope of the delivery can be
inserted into the now-visible shield mechanism, after the shield has
been removed.
Furthermore, it is possible to use the helmet without the face shield
but with the shield. For this combination, Touratech recommends
that you wear safety glasses.
EN
67