Chinstrap With Micro-Lock Ratchet Fastener; Adjusting The Chinstrap; Opening And Closing - Touratech AVENTURO MOD Manuel D'utilisation

C. THE HELMET
CLOSING THE CHIN BAR
To close the chin bar, pivot it down with
one hand until both locks audibly engage.
Note:
By closing the chin guard, the shield is returned to its starting
position.
Note:
Each time you close the chin bar, check that the locks have
engaged properly by pressing the chin bar upwards.
Tip:
When using the additional adjustable wind deflector, locking the
chin bar is easier if you grip the chin pad underneath with a finger
of your other hand to help you ease the chin bar over your chin.
Caution:
Never ride with the chin bar raised.
10. CHINSTRAP WITH MICRO-LOCK
RATCHET FASTENERS
The AVENTURO Mod comes with a
ratchet fastener. This locking system is
easy to use and enables you to adjust
the chinstrap perfectly to your head
everytime you put the helmet on.
64

ADJUSTING THE CHINSTRAP

The length of the chinstrap is adjusted by increasing or reducing the
length of strap pulled through the metal buckles. Adjust the length of the
chinstrap so that it fits firmly but comfortably under your chin and fix the
end of the strap using the retaining loop with comfort pad.
Caution:
When adjusting the strap, make sure that the helmet cannot be
pulled off in a forward direction with the chinstrap closed.
Caution:
Check the adjustment of the chinstrap length at regular intervals.
Opening and closing
To close the chinstrap fastener, slide the ratchet tongue step by step into
the locking buckle. If you find that the chinstrap fits too loosely around
your chin, slide the ratchet tongue one step further into the locking
buckle.
When adjusting the chinstrap, make sure that it rests firmly but not un-
comfortably around your chin. To open the chinstrap, pull the red ribbon
on the ratchet fastener upwards to release the locking buckle. Then pull
the ratchet tongue out of the locking buckle.
EN
65