Touratech AVENTURO MOD Manuel D'utilisation page 36

C. THE HELMET
REPLACING THE VISOR SHIELD
Changing the face shield is easy to do without tools using the conve-
nient EasyChange mechanism. To do so, the shield must be dismantled.
To replace the face shield, it is helpful to place the helmet on a flat
surface or on your lap while seated.
Removing the face shield
1. Move the face shield into the
uppermost locked position.
2. Press the spring underneath the
face shield mechanism on one side
towards the face shield opening,
then do the same with the spring on
the other side.
3. Move the face shield upwards until
it is released from the face shield
mechanism.
Installing the face shield
1. Using both hands, guide the
face shields locking studs into the
respective recesses in the face
shield mechanism.
70
2. The face shield will then audibly
lock into place when you press it
gently towards the helmet with a
simultaneous closing movement.
3. Make sure that the face shield
mechanism is functioning properly by
opening the face shield once to its
maximum extent.
ANTI-FOG LENS
Fitting
1. Lay the anti-fog lens in the face
shield in such a way that one side of
it is already slotted into the locking
pin.
2. Now grasp the other side of the anti-
fog lens by its upper and lower
transverse edges and use your index
finger to gently press the end of the
visor into a slight "S" shape. Now
you can easily guide the slot over the
locking pin and release the anti-fog
lens into place.
EN
71