Configuration Programmes; Spin Counter - Corghi EYELIGHT Plus DiagnosticLine Manuel D'utilisation

To display the list of Utility programmes, select
the Utility and Configuration programmes icon.
The programmes in this sub-menu are now
available:
1.

SPIN COUNTER

2.
SET MANUAL WHEEL DIMENSIONS
3.
W H E E L D I A G N O S I S P R O G R A M M E
4.
UNBALANCE OPTIMISATION PROGRAMME
5.

CONFIGURATION PROGRAMMES

1. SPIN COUNTER
Three counters are displayed on the screen:
-
the number of partial spins made since the
last manual reset;
-
the total number of spins performed by the
machine since its first start-up;
-
the number of wheel spins performed since
the last sensitivity calibration.
If the Weight Management suite is enabled, the
66
spin counter icon in the Utility programmes menu
becomes
-
-
-
-
-
The Reset button
reset the partial spin counters and the weight
quantity saved.
To quit the counter display, press the Exit but-
ton
If connected to an approved printer, the Print
menu secondary control key
used to start the print procedure for the Less
Weight programme.
EYELIGHT Plus DiagnosticLine - Operator's manual
and displays:
the total number of spins performed by the
machine since its first start-up;
the number of partial spins made since the
last manual reset;
the total weight quantity saved by the machine
since its first start-up;
the partial weight quantity saved since the
last manual reset;
two histograms that compare the quantity
of weight required if the "Less Weight" pro-
gramme (red bar) is not used and
the quantity required if the "Less Weight"
programme (green bar) is used for
the entire service life of the machine for clip
and adhesive weights.
.
can be used to
can be