Corghi EYELIGHT Plus DiagnosticLine Manuel D'utilisation page 71

more suitable criterion, according to your own
experience, from among the following:
calculates the optimal wheel position
based on tread wear;
calculates
position based on the drift angles (side slip);
calculates
position based on radial eccentricity;
calculates the optimal wheel position
based on unbalances;
11. Mount the wheels as shown in the image
located to the right of the screen.
If connected to an approved printer, the Print
menu secondary control key can be
used to start the print procedure for the iPos
programme.
To exit the programme without deleting the
measurements that were made, press Exit
.
To delete the displayed data and exit the
programme press Delete
buttons.
To deactivate the iPos programme from the
main operating screen, select
3.4. 3D wheel scanning programme
This programme is used to display the wheel or
the rim mounted on the wheel balancer in 3D,
therefore any deformations that are present can
be seen and measured.
The operator is able to change two parameters
related to scanning in the wheel balancer para-
meter configuration, i.e.:
- wheel or rim rotational speed (from a minimum
of 30rpm to a maximum of 70rpm);
- the steps made by the rear motor (from a mi-
nimum of 1 step to a maximum of 5 steps).
Based on any changes made to the parameters
EYELIGHT Plus DiagnosticLine - Operator's manual
the optimal wheel
the optimal wheel
then Save
.
indicated above, the resolution of the scan will
change, that is it will be increased (and there-
fore more precise) with the minimum speed
and steps and decreased (and therefore less
precise) with the maximum speed and steps.
Proceed as follows to perform the scan:
- Wait for the wheel balancer;
- start the RUN-OUT programme
- perform a spin, with automatic measurement
of the dimensions
end of the measuring cycle (measurement cycle
also includes the RUN-OUT measurement or
perform a spin with acquisition of the wheel
dimensions in the working environment and
then enter the ROD programme)
- now press the button
run-out environment) and wait for the end of
the external last scanning cycle.
When pressing the button
displays the points acquired of the complete
wheel or only the rim being examined.
;
and wait for the
(always in the
UK
the machine
71