Corghi EYELIGHT Plus DiagnosticLine Manuel D'utilisation page 72

Some indications follow as to what functions are
available with this programme:
1: 3D graphic of the complete wheel or only the
rim (in the figure, a 3D scan of a complete
wheel);
A: the yellow line indicates the position of the
wheel/rim mounted on the wheel balancer
at 12 o'clock;
B: cursor to rotate graphic 1 360°;
C: cursor to zoom graphic 1;
2: complete wheel/rim profile graph;
D: horizontal axis of the abscissae that indicates
the distance with respect to the casing edge;
E: vertical axis of the ordinates that indicates
the radius with respect to the shaft assembly
axis;
F: cursor for icon profile graphic zoom
: reset graphic factory settings.
4. UNBALANCE OPTIMISATION
This procedure reduces the total wheel unbal-
ance by compensating for the tyre unbalance
with the rim unbalance, if possible.
The machine indicates that the procedure needs
to be performed by displaying the following warn-
ing light
to perform the procedure whenever considered
necessary.
The calculations performed by this programme
are based on the unbalance values measured dur-
ing the last spin performed which must therefore
refer to the wheel being serviced.
OPT 1
- Move the valve to the 12 o'clock position.
72
. The operator can decide
EYELIGHT Plus DiagnosticLine - Operator's manual
- press the button
on the monitor to confirm the operation;
OPT 2
- Place the wheel in the 6 o'clock position as
indicated on the screen. If the RPA function
is enabled, the wheel is automatically placed
in position.
- Mark the 12 o'clock position on the outer side
of the tyre.
- press the button
on the monitor to confirm the operation;
OPT 3
- Remove the wheel from the wheel balancer
and using the tyre changer, line up the mark
on the tyre with the valve.
- Remount the wheel on the wheel balancer.
- press the button
on the monitor to confirm the operation;
OPT 4
- Move the valve to the 12 o'clock position.
- press the button
on the monitor to confirm the operation;
OPT 5
- Perform a spin by lowering the guard.
If significant improvements cannot be obtained,
the message "OUT" is displayed at the end of
the spin. In this case, we recommend quitting the
procedure by pressing the Exit button
The operator can decide to continue by press-
ing the button
the monitor.
OPT 6
Now, the real unbalance values of the wheel as it
is mounted on the wheel balancer are displayed.
- Place the wheel in the position indicated on
the screen. If the RPA function is enabled, the
wheel is automatically placed in position.
or the button
or the button
or the button
or the button
or the button on