Corghi EYELIGHT Plus DiagnosticLine Manuel D'utilisation page 70

abort the measurement.
3.2. Measurement of tyre tread height and wheel
side slip
This function in the Runout programme allows you
to measure tyre tread height and wheel side slip
as well as wheel runout.
To start the procedure, first select the
button, set it to ON, then perform a spin.
At the end of the spin, in addition to the run-out
icons and graphs, the following icons will also be
displayed on the screen:
-
average height of tread;
-
wheel side slip.
If the measured values exceed acceptable limits,
the values will be displayed in red.
3.3. iPos programme (intelligent positioning)
After checking the status of each wheel, the wheel
balancer uses this programme to automatically
suggest the optimal positioning of the wheel on
the vehicle, selecting one of the following criteria
indicated below:
- Tread wear.
- Tyre side slip.
- Radial run-out.
- Wheel unbalances.
To start the programme, proceed as follows:
1. From the main operating screen, select the icon
, an image of the vehicle is now displayed
at the centre of the main balancing screen.
To select the wheel to be checked, press directly on
the wheel itself on the image on the screen:
- if the front left wheel is to be analysed;
- if the front right wheel is to be analysed;
- if the rear right wheel is to be analysed;
- if the rear left wheel is to be analysed;
70
2. An image of the vehicle is now displayed
3. Mark the number that identifies the wheel on
4. Perform a spin to start the in-depth analysis
5. The analysed wheel is now displayed with
6. Repeat the operations described from point
7. Once all data has been saved access the
8. Now the following measurements are shown
9. To correctly calculate the wheel positions
10. Mount the wheels as shown in the image
located to the right of the screen. Otherwise,
if the criterion selected automatically by the
programme is not the one required, use the
secondary control key to manually select the
EYELIGHT Plus DiagnosticLine - Operator's manual
at the centre of the main balancing screen,
indicating the wheel to be analysed with the
following symbol
the external side of the tyre.
of the wheel. The spin cycle will take longer
than a normal balancing cycle.
the following symbol
1 to 4 for the vehicle's other three wheels.
programme for optimising the wheel position
on the vehicle by selecting the vehicle image
displayed in the centre of the screen.
in the windows for all four wheels:
tread wear
tyre side slip
radial run-out of the wheel.
select the type of tyre used using the arrows,
if necessary, from among the four available
types:
symmetric directional
asymmetric asymmetric directional
.
.