Corghi EYELIGHT Plus DiagnosticLine Manuel D'utilisation page 47

A
B
EYELIGHT Plus DiagnosticLine - Operator's manual
4
V
A
5
C
6
D
Wheel guard and related
support mounting procedure
- Install the bush (A, fig. 7) on the pivot (B, fig.
7). While doing this, ensure that the groove on
the pivot is aligned with the pin in the bush;
B A
- Block the bush on the pin using the M12 screw
supplied with the machine.
- Insert the metal tube (D, fig.8) into the two
plastic guard front holes (C, fig.8);
- Fasten the guard to the rear of the pipe, snap
fitting into the relative seat (E, fig. 8);
- Lock the guard by tightening the screw F (fig.8).
E
After assembling the machine, position it in the
selected place and make sure that the spaces
surrounding it are at least equal to the ones
indicated in Fig. 9
7
F
C
8
D
47
UK