Contact Information - MSA FireHawk M7XT Fonctionnement/Entretien

9. Prior to storage of the air mask at temperatures below
0˚F, verify that the FireHawk M7XT Power Module and
FireHawk M7 HUD or I-HUD are equipped with full
charge batteries. Verify that the FireHawk M7XT Control
Module displays a full charge battery status icon. Verify
that the FireHawk M7 HUD or I-HUD do not display low
battery status indicators.
Misuse can result in serious injury or death.
CBRN AGENT APPROVAL LABEL
CBRN Agent Approved
See Instructions for Required Component
Part Numbers, Accessories, and Additionall
Cautions and Limitations of Use.
The MSA CBRN Agent approved air mask has this approval
label attached to the carrier and harness.
IMPORTANT NOTICE FOR RESPIRATOR USERS AND RESPIRA-
TORY PROTECTION PROGRAM ADMINISTRATORS
1. An adequate respiratory protection program must include
knowledge of hazards, hazard assessment, selection of
proper respiratory protective equipment, instruction and
training in the use of equipment, inspection and mainte-
nance of equipment, and medical surveillance. [See OSHA
regulations, Title 29 CFR, Part 1910.134 (c).]
2. This SCBA may be used only after proper instruction and
training in its use as specified in NFPA-1500 and OSHA reg-
ulations Title 29 CFR, Part 1910.134.
3. Quantitative fit testing should be conducted to determine
proper facepiece size prior to using the respirator. A Fit
Test Kit (MSA P/N 10044576) is available for conducting
quantitative fit tests with the Ultra Elite Facepieces. The
facepiece donning instructions must be carefully followed
when using the respirator and when conducting fit tests.
4. The CBRN Firehawk Second Stage Regulator must be flow
tested every year and overhauled on a periodic basis. An
overhaul kit (MSA P/N 10048942) is available.
MSA 314 (L) Rev. 2 - 10128861
INTRODUCTION

CONTACT INFORMATION

In the event of a product concern, contact your local MSA
authorized repair center or distributor, who will provide the
necessary information to MSA for issue resolution. To report
any serious concerns, or to speak with a certification organiza-
tion, use the following contact information:
Manufacturer
MSA Customer Service
Phone: 1-877-MSA-FIRE
Certifying Agencies
National Institute of Occupational Safety and Health (NIOSH)
Phone: 800-CDC-4636
Safety Equipment Institute (SEI)
Phone: 703-442-5732
4