Pin Assignment For Input Signals From The Control Centre (E.g. Plc) - M12, 8-Pole Plug; Configuration; Pin Assignment For Output Signals To The Control Centre (E.g. Plc) - M12, 8-Pole Plug (Required For Analogue Output Option Only); Pin Assignment For Operating Voltage - M12, 8-Pole Circular Plug-In Connector - Burkert 8791 Manuel D'utilisation

13.2.2 pin assignment for input signals from the control centre
(e.g. plc) - m12, 8-pole plug
pin Wire color*
1 white
2 brown
5 grey
* The indicated wire colors refer to the connection cable, part no. 919061, available as an accessory.
Table 23: Pin assignment; input signals of the control centre - M12, 8-pole plug
13.2.3 pin assignment for output signals to the control centre
(e.g. plc) - m12, 8-pole plug
(required for analogue output option only)
pin Wire color*
8 red
7 blue
* The indicated wire colors refer to the connection cable, part no. 919061, available as an accessory.
Table 24: Pin assignment; output signals to the control centre - M12, 8-pole plug
13.2.4 pin assignment for operating voltage -
m12, 8-pole circular plug-in connector
pin Wire color*
3 green
4 yellow
* The indicated wire colors refer to the connection cable, part no. 919061, available as an accessory.
Table 25: Pin assignment; operating voltage - M12, 8-pole circular plug-in connector
60

configuration

Set-point value + (0/4 – 20 mA) 1
Set-point value GND
Binary input
configuration
Analogue feedback +
Analogue feedback GND
configuration
GND
+24 V
english
Type 8791
Electricalconnection
On the device
external circuit / signal level
side
+ (0/4 – 20 mA)
2 GND set-point value
+
5
with reference to Pin 3 (GND)
On the device
external circuit / signal level
side
8 + (0/4 – 20 mA)
GND (identical with the GND supply
7
voltage)
external circuit / signal level
3
24 V DC ± 10%
max. residual ripple 10%
4
0 – 5 V (log. 0)
10 – 30 V (log. 1)