Control And Display Elements; Display Elements Of The Linear Remote Sensor - Burkert 8798 Manuel D'utilisation

7 CONTROL AND DISPLAY
ELEMENTS
Special operation of this Remote Sensor is not necessary. The necessary
settings are made on the positioner Type 8791 or Type 8792/8793
(see relevant chapter of the positioner operating instructions).
7.1 Display elements of the linear
Remote Sensor
2 LEDs, which are also visible from outside through the transparent
cap, display the sensor mode.
Status Status
LED LED Display
green red
No operating
off off
voltage
Sensor is operated
flashing on outside the cov-
erage area.
flashing off Sensor is in operation and sending position value
Tab. 1: LED display elements; linear Remote Sensor
12
Remedial action
Check the supply voltage
of positioner
Type 8791,
Type 8792/8793.
Check the cable con-
nection configuration.
Check adaption to
actuator; the puck on
the switch spindle must
not exceed the sensor
surface.
english
Type 8798
Controlanddisplayelements
View without transparent cap
Status LED green
Status LED red
Fig. 6: LED display elements; linear Remote Sensor