Available Set-Up Parameters - Fronius TransTig 2200 Instructions De Service

Available set-up
dyn
parameters
dYn - dynamic - arc-force dynamic correction ...
(continued)
unit
setting range
factory setting
In order to obtain optimum welding results, it will sometimes be necessary to adjust the
"Dynamic (arc-force)" function. For details on setting the "dYn" parameter, please see
the section headed "Set-up menu", sub-section "Rod electrode set-up parameters".
Functional principle
At the instant of droplet transfer, i.e. when a short circuit occurs, there is a momentary
rise in the amperage. In order to obtain a stable arc, the welding current is temporarily
increased. If the rod electrode threatens to sink into the weld pool, this measure pre-
vents the weld pool solidifying, as well as preventing more prolonged short-circuiting of
the arc. This largely prevents the rod electrode from "sticking".
Setting range of the dYn parameter
0
100
FAC
Factory - for resetting the welding machine
Press and hold the Mode selection button (1) for 2 s to reset the machine to the factory
settings. When the display reads "PrG", the welding machine has been reset.
Important! When the welding machine is reset, all the personal settings in the set-up
menu are lost.
-
0 - 100
20
soft, low-spatter arc
harder, more stable arc
41