Fronius TransTig 2200 Instructions De Service page 96

TransTig control (6) Adjusting dial ... for altering parameters. If the indicator is lit up on the adjusting
panel
(continued)
(7) and (8) Parameter selection buttons ... for selecting the parameters
It is also possible to change parameters by means of the parameter selection buttons (7)
and (8) while the welding operation is in progress.
"Min." and "max." are used for setting ranges that differ according to power source .
Available parameters where 2-step (2) and 4-step (3) mode have been selected:
unit
setting range
factory setting
unit
TT 2200
TT 4000
TT 5000
Important! On welding torches with Up/Down functionality, the entire setting range can
be selected while the machine is idling. During welding, the main current can be cor-
rected in steps of +/-20 A.
unit
setting range
factory setting
Important! The downslope t
modes.
unit
setting range
factory setting
Available parameters where the "Rod electrode (MMA) welding" mode (5) has been
selected:
unit
MW 1700 Job
MW 2200 Job
MW 4000 Job
MW 5000 Job
dial, then the selected parameter can be altered.
Starting current I
S
%
0 - 200 % of main current I
35 AC
50 DC
Main current I
1
A
3 - 220
3 - 400
3 - 500
Downslope t
down
s
0,0 - 9,9
1,0
Final current I
E
%
0 - 100 % of main current I
30
Main current I
1
A
10 - 140
10 - 180
10 - 400
10 - 500
1
is saved separately for the 2-step and 4-step operating
down
1
14