Accessing; Shielding Gas Set-Up Parameters - Fronius TransTig 2200 Instructions De Service

Shielding gas set-up parameters

Accessing

1.
2.
Important! The first parameter to be displayed is always the one that was the last to be
selected the last time the set-up menu was accessed.
Selecting and 1.
altering the set- 2.
up parameter
1.
Saving and
exiting
Available set-up "Min." and "max." are used for setting ranges that differ according to power source, wire
parameters feed, welding program etc.
GPr
Gas pre-flow time
unit
setting range
factory setting
G-L
Gas-Low - gas post-flow at minimum welding amperage (minimum gas post-flow time)
unit
setting range
factory setting
+
(1)
While pressing and holding the "Mode" button (1), press the gas test button (14)
The first parameter is displayed (e.g. "GPr")
Select the desired set-up parameter with the parameter selection button(s).
Alter the value of the set-up parameter with the adjusting dial
Press "Store" button
s
0 - 9,9
0,4
s
0 - 40
5
(14)
35