Fronius TransTig 2200 Instructions De Service page 93

MagicWave
control panel
unit
(continued)
setting range
factory setting
Important! The downslope t
modes.
unit
setting range
factory setting
unit
setting range
factory setting
-5: highest fusing power, lowest cleaning action
+5: highest cleaning action, lowest fusing power
unit
setting range
factory setting
Available parameters where the "Rod electrode (MMA) welding" mode (5) has been
selected:
unit
MW 1700 Job
MW 2200 Job
MW 4000 Job
MW 5000 Job
(9) Welding current display ... for indicating the welding current for the parameters:
Downslope t
down
s
0,0 - 9,9
1,0
down
Final current I
E
%
0 - 100 % of main current I
30
Balance (only with TIG-AC)
1
-5 - +5
0
Electrode diameter
mm
0FF - max.
2,4
Main current I
1
A
10 - 140
10 - 180
10 - 400
10 - 500
I (starting current)
S
I (main current)
1
I (final current)
E
Before the start of welding, the left-hand display shows the command value. For I
and I , the right-hand display also shows the respective percentage of the main
E
current I .
1
After the start of welding, the parameter I
display shows the present actual value of the welding current.
The control panel indicates which position has been reached in the welding process
by dimming the parameters (I
is saved separately for the 2-step and 4-step operating
1
in.
0FF - max.
0.095
is automatically selected. The left-hand
1
, t , ...).
S down
11
S