Transtig Control Panel - Fronius TransTig 2200 Instructions De Service

TransTig control
panel
(13)
(7)
Fig.4
With TransTig power sources, the TIG-DC and rod electrode DC processes are availab-
le. The following processes and functions are not available and cannot be retro-fitted:
-
-
-
Important! To change over from the rod electrode DC- welding process to the rod
electrode DC+ welding process on TransTig power sources, reconnect the electrode
holder and the earthing (grounding) cable to the opposite welding sockets (i.e. swap
them over - see the section headed "Rod electrode (MMA) welding").
(1) Mode button ... for selecting the operating mode
Warning! Operating the equipment incorrectly can cause serious injury and
damage. Do not use the functions described here until you have read and
completely understood all of the following documents:
- these Operating Instructions
- all "Operating Instructions" for the system components, especially the
"Safety rules"
(12) (9)
TransTig 5000 control panel
TIG-AC welding
Rod electrode AC welding
Switchover facility between the rod electrode DC- and rod electrode DC+ welding
processes
(2) 2-step mode
(3) 4-step mode
(4) Rod electrode (MMA) welding
Important!If you select "Rod electrode (MMA) welding" mode (4), the welding
voltage will only be available after a 3-second time lag.
(11) (10)
(6) (8)
13
(3) (2)
(14) (1)
(4)