Rod Electrode Set-Up Parameters; Accessing - Fronius TransTig 2200 Instructions De Service

Rod electrode set-up parameters

Accessing

1.
2.
3.
Important! The first parameter to be displayed is always the one that was the last to be
selected the last time the set-up menu was accessed.
Selecting and 1.
altering the set- 2.
up parameter
Saving and 1.
exiting
Available set-up "Min." and "max." are used for setting ranges that differ according to power source.
parameters
HCU
Hot start current
unit
setting range
factory setting
Hti
Hot current time
unit
setting range
factory setting
In order to obtain optimum welding results, it will sometimes be necessary to adjust the
Hot-Start function.
Advantages:
-
-
-
Press the "Mode" button (1) to select the "Rod electrode (MMA) welding" mode (4)
(4)
+
(1)
While pressing and holding the "Mode" button (1), press the parameter selection
button (8).
The first set-up parameter is displayed (e.g. "HCU")
Select the desired set-up parameter with the parameter selection button(s).
Alter the value of the set-up parameter with the adjusting dial
Press the "Mode" button (1)
%
0 - 100
50
s
0 - 2,0
0,5
Improved ignition, even when using electrodes with poor ignition properties
Better fusion of the base metal in the start-up phase, meaning fewer cold-shut
defects
Largely prevents slag inclusions
(8)
40