Connection To External Exhaustion System; Mounting An Extra Cutting Table/Quick-Clamping Device; Mounting The Quick-Clamping Device; Explanation Of Safety Factors - Struers Unitom-2 Manuel D'instructions

Connection to External
Exhaustion System
Mounting an Extra Cutting
Table/Quick-Clamping Device
Mounting Cutting Table 2
Mounting the
Quick-Clamping Device

Explanation of Safety Factors

Unitom-2
Instruction Manual
Struers recommends the use of exhaustion as the materials to be cut
may emit harmful gasses or dust.
On the back of Unitom-2 you will find a joint for a 50 mm dia.
exhaustion hose.
Remove the red cap.

Mount an exhaustion hose from your local exhaustion system

onto the joint.
Unitom-2 is delivered with one cutting table with a quick-clamping
device, but it is often useful to have an extra cutting table for irregular
workpieces.
Remove the 4 plastic knobs in the bottom of the cutting chamber.

The second cutting table must be mirrored compared to the first

cutting table.
Adjust the second cutting table to parallel position and a distance

of 6 mm compared to the original cutting table.
Clean the cutting table with the flush hose.

Place the back stop parallel to the back stop of the original

cutting table. Use a steel ruler to adjust the position.
Tighten the back stop.

Place the quick-clamping device parallel to the quick-clamping

device of the original cutting table and tighten it.
Please refer to the Struers Clamping Tools brochure
range available.
The protection guard has a safety switch to prevent the cut-off wheel
from starting while the guard is open. Furthermore, a locking
mechanism prevents the opening of the protection guard before the
cut-off wheel is standing absolutely still.
for details of the
15