Display; Main Switch; Mounting Method Options - Struers ProntoPress-20 Mode D'emploi

Display

Main Switch

Mounting Method Options

14
ProntoPress-20
Instruction Manual
A
B SELECT METHOD GROUP
1. STRUERS
3. GROUP NUMBER 3
F1:CONFIG.
C
Heading.
A
Flashing text. Cursor.
B
Function key options.
C
Arrow indicates, that there are more lines in the picture.
D
The examples of display screens in this Instruction Manual show a number
of possible texts. The actual display screen may differ from the examples in
The mounting press will start in the same state, as when the
voltage was last switched off. If a mounting method was selected
at that time, this method will appear on the display.
Grp: 2 Method: 3
HEAT: Time: 7:00
COOLING:
F1:SELECT PREHEATING
If this mounting method can be used again, go to the section
Starting the Mounting Process.
If a new mounting method should be used, go to the section
Selecting a Mounting Method.
If some of the parameters have to be changed, go to the section
Method Edit.
2. GROUP NUMBER 2
4. GROUP NUMBER 4
F3:MAN. FUNC.
Please Note
the Instruction Manual.
Front panel
Main switch
Resin:MultiFast
T: 180°C
Rate: HIGH Time:
D
F: 20 kN
3:00