Basic Settings; Changing The Basic Settings - HYDAC ELECTRONIC ETS 3000 Notice D'utilisation

ETS 3000
8.

Basic Settings

The ETS 3000 can be adapted to suit the particular application as required by changing the
basic settings. These settings are located in a single menu.
8.1

Changing the Basic Settings

Important note: When the menu is activated, no switching operations are carried out.
Activating the Basic Settings menu:
HYDAC
SP2
SP1
3 s
mode
Press the mode key and
hold it down. Switch
on the power supply.
(Hold key down
until "Menu"
appears in the display.)
To exit the Basic Settings menu:
Select the END menu item, set to YES: the ETS 3000 returns to normal display mode after
2 s.
Note:
• If no key is pressed for approx. 25 seconds, the menu closes automatically. Any changes
that may have been made will not be saved.
Status 17.08.2016
HYDAC
SP1
Display
Hold mode key down
(Release the
until the required menu item
mode key.)
appears in the display.
Then release the key.
(For overview, see section 8.2)
(For overview, see section 7.2)
HYDAC ELECTRONIC GMBH
HYDAC
SP1
SP2
mode
Change the setting using
then select the next menu item.
Page 9
SP2
mode
or
Part No.. 669859