Analogue Output; Setting The Switching Points And Hysteresis Or Switching Values For Window Mode - HYDAC ELECTRONIC ETS 3000 Notice D'utilisation

ETS 3000
7.2

Analogue Output

Analogue output signal:
7.3 Setting the Switching Points and Hysteresis or Switching Values for Window
Mode
• Press the mode key.
• S.P.1 or Lo.1 appears in the display.
• Press the mode key repeatedly to scroll through to the required parameter.
(S.P.1, hYS.1, S.P.2 or hYS.2 appears when switching point mode is set; Hi.1, Lo.1, Hi.2
or Lo.2 appears when window mode is set)
• After 2 seconds the actual setting will flash.
• Change the setting using the
• If necessary, use the mode key to select further parameters, and the
change the setting.
• The display switches back automatically if no keys have been pressed for 3 s; the settings
are saved.
HYDAC
°C
°C
SP2
SP1
mode
Press the mode key
until the required
parameter is reached
Notes:
• If "
appears in the display while attempting to change a setting, this means that
LOC"
programming is disabled (locked).
Corrective action: Set the program enables to "
Enables))
• If the
or key is held down while making a change, the value will automatically
advance.
• When a setting has been changed,
over to another display mode. The new setting has then been saved.
Status 17.08.2016
4 – 20 mA or 0 – 10 V
(can be set in the Basic Settings menu)
and keys.
°C
2 s
Display Actual
switching point 1
PRoG
HYDAC ELECTRONIC GMBH
HYDAC
°C
SP2
SP1
mode
Adjust the switching point:
=decreases value
=increases value
. (see section 9 Programming
free"
appears briefly in the display when it switches
Page 7
and keys to
HYDAC
°C
SP2
SP1
3 s
mode
Part No.. 669859