Technical Safety; Exclusion Of Liability - HYDAC ELECTRONIC ETS 3000 Notice D'utilisation

ETS 3000
1.

Technical Safety

The individual components of the ETS 3000 Electronic Temperature Sensor and the
assembled unit are subject to strict quality assurance. Each ETS 3000 undergoes a final
test. This ensures that when supplied the sensor is free of defects and complies with the
designated specifications.
The series ETS 3000 electronic temperature sensors are maintenance-free and operate
perfectly when used under the conditions specified. If, however, you do encounter problems,
please contact your HYDAC representative. Any tampering with the sensor will invalidate all
warranty claims.
Compliance with European Standards
The ETS 3000 series electronic temperature sensors feature the
with all the German approval requirements and the European standards currently applicable
for operating these units. As a consequence, compliance with the current regulations on
electromagnetic compatibility and the safety provisions of the Low-Voltage Directive is
ensured.
This product complies with the provisions of the following European standards:
EN 61000–6–1 / 2 / 3 / 4
We reserve the right to make technical modifications.
General Safety Information
The ETS 3000 series electronic temperature sensor presents no safety risk provided it is
used in accordance with its proper, designated use. However, in order to avoid any risk to
the operator or any damage due to incorrect handling of the unit, please adhere strictly to the
following safety instructions:
• The ETS 3000 must not be put into service if any known defects, either electrical or
mechanical, are apparent.
• The instructions for use must be strictly adhered to.
• Read the specifications on the rating plate.
• Troubleshooting and repair work may only be carried out by HYDAC's Service
Department.
• All relevant and generally recognized safety requirements must be adhered to.
2.

Exclusion of liability

This operating manual was made to the best of our knowledge. Nevertheless and despite
the greatest care, it cannot be excluded that mistakes could have crept in. Therefore please
understand that in the absence of any provisions to the contrary hereinafter our warranty and
liability – for any legal reasons whatsoever – are excluded in respect of the information in
this operating manual. In particular, we shall not be liable for lost profit or other financial loss.
This exclusion of liability does not apply in cases of intent and gross negligence. Moreover, it
does not apply to defects which have been deceitfully concealed or whose absence has
been guaranteed, nor in cases of culpable harm to life, physical injury and damage to health.
If we negligently breach any material contractual obligation, our liability shall be limited to
foreseeable damage. Claims due to the Product Liability shall remain unaffected.
In the event of translation, only the original version of the operating manual in German is
legally valid.
Status 17.08.2016
HYDAC ELECTRONIC GMBH
Page 3
mark and thus comply
Part No.. 669859