Spare Parts; Gear Box Lubrication; Turntable Trolley Check - SICE S50A Mobile Manuel D'instructions

Maintenance programme
Daily
Weekly
Monthly
Periodically

4.2 Spare parts

Refer to the specific spare part manual.

4.3 Gear box lubrication

The gear box of S50A Mobile tyre changer is NOT filled with "LONG LIFE" grease.
Should the grease in the gear box need to be replaced, use one of the following grease type (or a similar one):
Vanguard ML00EP; BP FG00EP; Esso Transmission Grease EP; IP Atina; Mobil Mobilplex 44; Shell Simnia 0; Total Carter
SY00.
The necessary quantity of grease is 1500 gr. (48.2 oz)

4.4 Turntable trolley check

Periodically check the turntable trolley, in order to prevent excessive clearance
between guide rails and sliding blocks and, therefore, irreversible damage to
mechanical moving parts.
If the clearance is evident, adjust the sliding blocks as described below.
ADJUSTING THE SLIDING BLOCKS
Disconnect the machine from the electric power supply.
Loosen the 4 nuts (3) fixing the upper left sliding block.
Loosen the 4 nuts fixing the lower left sliding block (4).
Loosen the 4 nuts (5) locking the adjuster on the trolley left side.
Alternately tighten the 4 screws (6) until the sliding blocks are in contact with the
guide rails.
62
Carry out the following maintenance
Check for any rubber and nylon components which are damaged and need to be
replaced in order to prevent damage. Replace any worn components.
Clean all the areas in contact with rims or tyres in order to prevent any scratches
on the rims.
Clean the tyre changer with workshop clothes or a vacuum cleaner. Do not
use compressed air jets for cleaning, since they can eject dirt on moving
parts.
Check all the controls to make sure that they activate the intended functions.
Grease all the moving parts.
Periodically check the oil level of the hydraulic control unit using the designated dipstick
located on the control unit cap.
If necessary, top up with:
MANUfACTURER OIL TYPE
AGIP OSO32 - ARNICA68
ESSO NUTO32 - INVAROL EP68
FINA HYDRAN32 - IDRAN HY68
SHELL TELLUS OIL32 - TELLUS OIL 68
API CIS32 - HS68
Should it be necessary to replace the control unit oil, remember that the tank is equipped
with a designated drain cap.
S50A Mobile Operator's Manual