Leica Microsystems DMI3000 B Mode D'emploi page 67

Variable Function Buttons on the Stand
The variable function buttons are assigned func-
tions at the factory that are appropriate to the
features of your microscope. They are labeled
accordingly. For details on button assignments,
please refer to the included identifi cation sheet.
For information on the abbreviations used, please
refer to the list → p. 63.
Note:
The Leica Application Suite (LAS) software is re-
quired for changing the button assignments.
Possible functions*:
BF
CHANGE CUBE CW
PH
CHANGE CUBE CCW
INT FLUO ↑
ICT
INT FLUO ↓
DF
FD FLUO ↑
IMC
FD FLUO ↓
POL
CHANGE TL
CHG FW
INT ↑
IFW
INT ↓
ExMan
AP ↑
COMBI
AP ↓
CHANGE COMBI
FD ↑
CHANGE OBJ CW (only DMI6000 B)
FD ↓
CHANGE OBJ CCW (only DMI6000 B)
SHUTTER TL
Z FINE (only DMI6000 B)
TL FLT 1
Z COARSE (only DMI6000 B)
TL FLT 2
XY PRECISE
FLUO
XY FAST
CUBE 1
BTP ON/OFF (only DMI6000 B)
CUBE 2 DRY/IMM
CUBE 3
CHANGE FLT
CUBE 4
CHANGE CS
CUBE 5
OBJ 1-6
CUBE 6
MEM 1-6
AFC ON/OFF
Turns AFC on or off
AFC HOLD
Holds current position
* See page 63 for abbreviations
Fig. 85 Function buttons (left side of stand)
1 Variable function buttons
2 Open/close aperture diaphragm
3 TL/IL switching
4 Open/close fi eld diaphragm
5 Increase/decrease light intensity
Fig. 86 Function buttons (right side of stand)
1 Variable function buttons
7. Start-up
1 2 3 4 5
1
67