Leica Microsystems DMI3000 B Mode D'emploi page 54

6. Assembly
Leica DMI3000 B:
To equip the turret disk with fi lter cubes, the tur-
ret disk must be removed from the stand (left side
of stand, Fig. 68).
The supports of the disk are labeled Pos1 to Pos5
(Fig. 69).
• Pull the fi lter slider out of the stand.
• Insert the fi lter cubes in the supports so that
the labeling is upside down.
To do this, position the fi lter cube at the left
side and engage it to the right in the mount.
One position of the turret disk must remain free
for transmitted light bright fi eld.
• When all fi lter cubes are inserted, push the
fi lter slider to the stop again in the left stand
side.
Fig. 68 Removing the fi lter slider
54
Fig. 69 Filter slider