Installation And Replacement Of Incident Light Lamps - Leica Microsystems DMI3000 B Mode D'emploi

6. Assembly
6.12 Installation and Replacement
of Incident Light Lamps
Caution!
Light sources pose a potential irradiation risk
(glare, UV-radiation, IR-radiation). Therefore,
lamps have to be operated in closed hous-
ings.
Ensure that the lamp housing has been dis-
connected from the power supply. Unplug the
power plug and the power supply during as-
sembly.
During assembly work on xenon burners, al-
ways wear the supplied protective gloves and
face protection (Fig. 58) (risk of explosion).
Never touch the glass parts of the burner
with bare hands.
Never look directly into the beam path (blind-
ing hazard).
Fig. 58
Protective gloves and mask
48
Lamp Housing 106 z
This lamp housing is suitable for use with a 12 V
100 W halogen lamp or a variety of gas discharge
lamps.
Caution!
Make sure to follow the instructions and
safety notes of the lamp supplier.
Before changing lamps allow at least 30 min-
utes for cooling down!
Fig. 59 Lamp housing 106 z L with Hg 100 W lamp
1 Collector focusing
2 Vertical lamp adjustment
3 Horizontal lamp adjustment
4 Hg lamp mount
5 Refl ector adjustment (not visible)
2
5
3
1
4