Connection To The Electronics Box - Leica Microsystems DMI3000 B Mode D'emploi

6. Assembly

6.17 Connection to the Electronics Box

CTR4000, CTR5000, CTR5500, CTR6000,
CTR6500, CTR7000, CTR6500 HS, CTR7000 HS
The Leica DMI 3000 B is supplied without an
electronics box. The power supply is integrated
in the stand and a socket has been provided on
the back of the microscope to connect the trans-
mitted light illumination. The illuminated ON/OFF
switch is located on the stand.
Fig. 77 Rear view of electronics box, example: CTR6000
1 AC power socket
2 XY Stage socket for motorized stage
3 Direct interface socket optional
4 Z Control for separate focus control
5 XYZ Control for SmartMove
6 Microscope socket for microscope
7 12 V, max 100 W for the lamp power cable of stand
8 DL: reset button
8
5
4
3
2
1
58
CTR 4000 Electronics Box
The Leica DMI 4000 B is supplied with the
CTR4000 electronics box. The power supply
for the microscope is located in this box. Two
sockets are located on the back of the CTR4000
electronics box for 12V/100W transmitted light
and 12V/100W incident light illuminators. The il-
luminated ON/OFF switch for the microscope is
located on the CTR4000 electronics box.
Fig. 78
1 RS232 ports
2 2 x USB
3 4 x EXT.
4 XYZ control for SmartMove
5 Electronic box connection
6 Condenser cable
7 Lamp power cable
6
1
7 2
Rear view of stand
3
7
6
5
4