Leica Microsystems DMI3000 B Mode D'emploi page 53

The positions in the turret disk are numbered. De-
pending on your equipment, the individual fi lter
and refl ector cubes have already been assigned
to specifi c positions at the factory. For details,
check the identifi cation sheet included with your
order.
Now open the drawer several mm further until
it clicks into its end position. Actuate the lever
(66.1) to engage the turret disk in the loading po-
sition.
You can now insert a fi lter block. Proceed as fol-
lows:
• With the holder facing you squarely, insert
the fi lter or refl ector cubes into the holder in
accordance with the included identifi cation
sheet.
• The fl uorescence cubes are suitable for both
upright and inverted microscopes. When using
them with inverted microscopes, insert them
so that the writing is upside down along the
lower edge.
To do so, place the fi lter or refl ector cube on
the left side and press it to the right into the
mounting (Fig. 67).
• Ensure that the cube is correctly seated. A
loose cube can block the disk or be destroyed
by the turning disk.
• Release the lever (66.1) again to turn the disk
on to the next loading position. Continue in this
way for all of the cubes.
• Once all fi lter and refl ector cubes have been
inserted, close the drawer and replace the
analyzer or cap.
Replacing Cubes with the Instrument Switched
On:
• Remove the analyzer or the cap of the analyzer
slot.
• Press and hold the Shutter button on the front
panel and press the button of the cube you
would like to insert or replace at the same
time.
• The fi lter changer will then rotate to the cor-
rect position to insert or replace the cube
when you open the drawer by pressing the
white button on the right side of the stand.
The following message will appear in the top
line of the LeicaScreen.
To insert the cubes, proceed exactly as described
above.
6. Assembly
Load!
53