Special Cases - Moustache Lundi 27 Manuel D'utilisation

Only one fitting bolt
If you have only found one fitting block, you are in the right
section. To adjust the angle of your saddle you need to carry
out the following process:
1. Loosen the screw that holds the saddle and seat post
using a 6mm allen key as in Figure 8 to obtain enough
play to easily move the saddle.
2. Adjust the angle and setback of the saddle as suits
you.
3. Tighten the screw, ensuring that it does not surpass
the maximum torque level indicated next to the screw.
4. Check that the screw is correctly in place and that there
is no play.
Two fitting bolts
If you have found two fitting blocks, you are in the right section. To adjust the angle of your
saddle you need to carry out the following process:
1. Loosen the two screws that hold the saddle and seat post using a 5mm allen key
(see Figure 9) until the saddle can move easily.
2. Adjust the angle and setback of the saddle as suits you.
3. Tighten each screw a half-turn, alternating between the two, without going over the
maximum torque level that is indicated next to them.
4. Check that the saddle is correctly in place and that there is no play.

3.2.3 Special cases

You can't find the right explanation for your bike? You can check the Moustache technical
notice available on our website www.moustachebikes.com/en/manuals/, in the Supports
section to obtain detailed information on your model.
Figure 9. Steps for tightening/loosening the fitting blocks.
57
Figure 8.
Tightening/loosening the fitting block.
EN