Moustache Lundi 27 Manuel D'utilisation page 66

4 // SETTINGS AND VARIOUS RECOMMENDATIONS
For suspension models with Air/Oil cartridge system
Before starting, ensure you have a high pressure pump and your usual riding gear.
• Place the rubber O-ring against the fork leg.
• Sit on the bike in a normal position and wearing your usual riding kit (helmet, bag and
accessories...). You can lean against a wall in order to avoid any brusque movements
on the bike.
• Step off your bike gently to avoid a harsh movement and measure the "SAG" (see
figure). A SAG that is too weak indicates that there Is too much pressure in your fork. You
should therefore take out air from your suspension. Inversely, a too high SAG indicates
that there is not enough, you should therefore, add air. To do this:
• Unscrew the valve cap to access the fork valve that enables you to adjust the air
pressure as in the following figure:
• Using a high pressure pump, adjust the fork's air pressure in order to get the desired
SAG as in the figure above. Be careful to not pass the maximum air pressure that your
fork can handle! This value can be found In the manufacturer's notice.
• Sit on the bike as described previously and check the SAG. Repeat these steps until you
find the right level.
Hint: If your fork is not equipped with a rubber O-ring that you can use to see the SAG position,
you can place a plastic zip tie on the fork stanchion which will carry out the same function.
Other settings can be carried out so you profit as much as possible from your suspension
system. Refer to the dedicated notice or go to your local bike retailer.
66