Moustache Lundi 27 Manuel D'utilisation page 67

Masquer les pouces Voir aussi pour Lundi 27:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
4.4.4 Setting the pre-tensioning of the rear shock (SAG)
Before starting, ensure you have a high pressure pump and your usual riding gear.
The process to set the SAG on your shock is very similar to that of
your fork. You simply need to follow these steps:
• Place the rubber O-ring against the shock's body.
• Sit on the bike in a normal position and wearing your usual
riding kit (helmet, bag and accessories...). You can lean against
a wall in order to avoid any brusque movements on the bike.
• Step off your bike gently to avoid a harsh movement.
Your Moustache is equipped either with a sticker indicating the level of
SAG with a red sliding scale. The ideal SAG has been reached when
the O-ring is aligned with the red scale as in Figure 22. If the O-ring
has gone further than this mark your shock needs more air. Inversely, if
the ring has not reached the mark, there is too much air in your shock.
To adjust the level of air in your shock:
• Unscrew the valve cap to access the shock's valve that enables you to adjust the air
pressure (See Figure23).
• Using a high pressure pump, adjust the shock's
air pressure in order to attain the desired level
of SAG. Be careful to not go over the maximum
air pressure level that your shock can cope with!
This level can be found In the Moustache technical notice
available on our website www.moustachebikes.com/en/
manuals/ in the section called «Supports».
• Sit on the bike as described previously and check the
SAG. Repeat these steps until you find the right level.
67
Figure 22. SAG Adjuster.
Figure 23. Manipulating the valve cap.
EN

Hide quick links:

Publicité

Table des Matières
loading

Table des Matières