Electric Connection; Power Plug - Steel Cucine GENESI 90x60 Manuel D'utilisation

Instructions for the installer
3.5

Electric connection

Make sure that the voltage and capacity of the power line conform to the data shown on the plate
located on the back of the appliance; a copy is attached to the manual.
A second plate, including detailed information about the model and serial number, is placed inside
the equipment on the left side and is visible on opening the oven door.
These plates must never be removed.
The plug at the end of the power supply cable and the wall socket must be the same type and must
comply with current electric standards. Check that the mains is adequately earthed. Once the
appliance has been installed make sure that the plug is accessible to allow the periodical check-up.
Prepare an omni-polar cutoff device on the power supply line of the appliance with a contact
opening distance equal to or more than 3 mm, located in a convenient position near the appliance.
Do not use reducers, adapters or shunts.
Before making the electric connection, make sure of the efficiency of the earthing.
Make sure that the relief valve and the home wiring system are able to withstand the appliance
load.
The yellow/green earth cable must not be subject to cutoffs.
The electric cable must not come into contact with parts whose temperature is more than 50°C
higher than room temperature.

3.5.1 Power plug

All our ovens are supplied with a single-phase electrical connection.
For greater practicality, we suggest fitting a plug to the oven according to the following wire colours:
yellow/green: earth wire;
•
black/brown: phase;
•
blue: neutral.
•
For other connections follow the instructions in chapter " 3.5.2 Type of power supply".
49