Assembly (Fig. 5); Connecting The Mortar Hose - WAGNER PLASTCOAT 1030 Mode D'emploi

GB
COMMISSIONING
6.2.2

ASSEMBLY (FIG. 5)

Disconnect external controls. Assembly
may only be carried out by the person
who controls the machine.
Never operate mortar spraying machine
with an exposed rotor.
Do not reach into the rotor when it is
moving. Risk of crushing.
Caution if you have long hair. Only wear
close-fitting clothes at work.
Loosen the star screws (1) and remove the outlet unit (2).
Spray the stator (3) and rotor (4) with a suitable pump lubri-
cant (order no. 9992 824).
Move selector switch (6) to "A" and set delivery volume con-
troller (7) to „0".
Connect mains plug to mains power supply.
The operation light (8) shows operational readiness.
The red indicator light (9) flashes during the function check for
about 30 seconds.
Set delivery volume controller (7) to 1 or 2.
Push the stator (3) over the tip of the rotor (4) (guide rail (5)).
Set the selector switch (6) to „R" to push the stator automati-
cally on to the rotor.
As soon as the stator is in end position, set the selector switch
(6) to „A".
Re-assemble the outlet unit (2) and tighten the star screws (1).
6.3

CONNECTING THE MORTAR HOSE

• Check that the pump unit is seated firmly.
• Connect the mortar hose (Fig. 7, 1) and secure it with the
clamping levers (Fig. 7, 2).
• Connect the atomizing air connection at the mortar hose
to the compressed air supply, for example the compressor
(accessory).
38
4
5
1
2
Plast Coat 1030
3
2
3
1
9
8
POWER ERROR
SPEED
6 7