Automatic Spray Lance; Connecting The Mortar Hose; Compressor (Accessory); Connecting The Spray Lance - WAGNER Plast Coat 830 Mode D'emploi

Plast Coat 830

AutOMAtIC SPRAy LANCe

6.3

CONNeCtING tHe MORtAR HOSe

• Check that the pump unit is seated firmly.
• Connect the mortar hose (Fig. 7, 1) and secure it with the
clamping levers (Fig. 7, 2).
• Connect the atomizing air connection at the mortar hose
to the compressed air supply, for example the compressor
(accessory).

1
6.4

COMPReSSOR (ACCeSSORy)

Place the compressor at a secure location next to the mortar
spraying machine and connect it to the mains network.
Note:
Only operate the compressor in accordance with the enclosed
operating manual.
6.5
CONNeCtING tHe SPRAy LANCe (FIG. 10)
• Mount the texture tip (1) in the spray lance with the cone
pointing towards the spray head.
the tip size should amount to at least three times the
granular size,
e.g. granular size Artificial resin plasters –>
tip size
• Connect the spray lance (2) and secure it with the clamping
levers (3).
• Close the material tap (4) (material tap at 90° to spray
lance).
• Screw coupling plug (5) for remote control to the control ca-
ble of the mortar hose.
• Connect atomization air connection (6) to the air hose of the
mortar hose.
• Connect mortar hose's control cable to pump connection.
(Fig. 11)
• Set selector switch to "A".
2
–> 10 mm

PNeuMAtIC SPRAy LANCe

6.3.
CONNeCtING tHe MORtAR HOSe
• Check that the pump unit is seated firmly.
• Connect mortar hose (Fig. 7, 1) to reduction piece and se-
cure with clamping levers (Fig. 7, 2).
• Connect atomising air connection on mortar hose to front
connection (Fig. 8,1) and compressor air hose (accessory) to
rear connection (Fig. 8,2).

2
6.4
COMPReSSOR (ACCeSSORy)
Place the compressor at a secure location next to the mortar
spraying machine and connect it to the mains network.
Note:
Only operate the compressor in accordance with the enclosed
operating manual.
6.5
CONNeCtING tHe SPRAy LANCe (FIG. 12)
• Select a spray tip suitable for the material:
type of material
Fine grain
3 mm
Coarse grain
the tip size should amount to at least three times the
granular size,
e.g. granular size
• Insert tip (1) at front in spray lance (2) and secure with ring
(3).
• Fit spray lance with reduction piece (4) on mortar hose (5)
and secure with clamping levers (6).
• Close material tap (7) (facing to the rear)
• Couple atomising air connection (8) to air hose on mortar
hose.
• Set selector switch to "A".
commIssIonIng
1
tip
3 mm (blue)
4 mm (red)
5 mm (yellow)
6 mm (black)
7 mm (green)
8 mm
10 mm
12 mm
Artificial resin plasters –>
tip size –> 10 mm
GB
3 mm
45