Safety Requirements; Electrical Equipment - WAGNER PlastCoat PC15 Mode D'emploi

GB

SAFETY REQUIREMENTS

1
SAFETY REQUIREMENTS
All local safety regulations in force must be
observed.
In addition, you must comply with the following:
Use of the mortar spraying machine
The mortar spraying machine PlastCoat 15 is designed only
for the spraying the materials described on page 37.
Any other use is not permitted. The manufacturer cannot be
held liable for any damage resulting from this. In such cases,
the risk will be borne solely by the user.
Intended use also includes compliance with the Operating
manual and compliance with the inspection and servicing
conditions.
Always keep the Operating manual ready at hand at the ma-
chine location.
The mortar spraying machine PlastCoat 15 may only be opera-
ted with a pressure gauge. Only the mortar hose prescribed by
the manufacturer may be used.
Only use identified mortar hoses with an operating pressure
of at least 40 bar.
Personnel safety
Always wear protective goggles,protective clothing and gloves
and, if necessary, skin barrier cream and breathing equipment,
to protect your eyes, skin and respiratory system
Never uncouple mortar hose while it is still under pressure.
Note pressure gauge!
Wear protective goggles!
Never aim spray lance at any person!
Breathing masks
Breathing masks must be provided for the operator to protect
against mineral dust.
Only connect to the mains supply using a special distribu-
ting point, e.g., using site distribution system with fault
current protection with INF≤ 30 mA.
Do not put a load of more than 450 watts on the socket on the
control unit.
The master switch has an EMERGENCY OFF function.
Prevent the socket for the remote control on the control unit
from getting dirty.
Always leave the coupler plug of the remote control line on
the mortar hose screwed complete into the control unit.
36
Danger of injury from the screw conveyor.
Never put your hands into the receptacle
when the mortar spraying machine is run-
ning.
Never turn on the mortar spraying machi-
ne when the grating has been removed
from the receptacle, when the receptacle
has been removed or if there is no contai-
ner connection plate.
Cleaning and servicing
Never uncouple mortar hoses under pressure. Before uncoup-
ling, check pressure on the pressure gauge.
Turn off the mortar spraying machine for cleaning and main-
tenance work.Pull out mains plug and ensure that it cannot be
plugged back in unintentionally.
Do not spray the motor or control unit of the mortar spraying
machine with water jet, high-pressure or steam cleaning
equipment. Water could penetrate the machine and cause a
short-circuit.

Electrical equipment

Work on the machine's electrical equipment may be carried
out only by a qualified electrician.
The electrical equipment must be inspected regularly. Defects
such as loose connections or scorched cables must be reme-
died immediately.
Keep the labels on the mortar spraying machine clean and
legible.
Positioning on uneven ground
The front of the mortar spraying machine must point upwards
to avoid that the machine slips away.
1
Plast Coat 15