Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Automatic Transfer Switch
OPERATION
ATyS 6s et 6e
Presentation
The product allows:
• sources control,
• automatic transfer control in AUT mode,
• parameters configuration,
AUT
Led is on when automatic mode is active
Sources state
- Led is on : source = OK
- Led is off : source is not available
Operational modes
- Automatic sequence simulator
(test on load)
- Genset remote start (test off load)
- Changeover switch position
control (local or remote)
Changeover switch position indication
Position O, I or II.
Manual operation
• Insert handle
• Only possible in
mode,
not padlocked
SOFTWARE VERSION
Displayed after reset.
(3 minutes power off action to allow the reset).
SOCOMEC - Réf.: 531 848 F
ATyS
LCD
7 digits + 14 pointers
Switch state
2 green leds:
- switch I state
- switch II state
Led is on when switch is closed
Yellow led (O) is on when both switches are
opened.
Presentation
Operationnal modes
Programming
Operation
Visualisation
Automatic sequences
• voltage and frequency (6e) metering,
• system state display,
• alarm or fault indication,
Padlock
Yellow led is on when
product is padlocked.
Keypad
Operations
LCD & leds test
Escape
Key switch (selector)
• Insert key
• Turn right for AUT mod
• Turn left for
Padlock
• Only possible in O position (1 and 2 as option)
• Remove handle
• Pull padlocking mechanism to allow
padlock insertion.
Product Version
Product Version
number
number
FAULT led
Led is on where product is faulty.
Disconnect power supplies to
reset.
POWER led
Green led is on when product is
powered.
Navigation
Validation
mod.
107
Publicité
Table des Matières
