Shift The Pump To Servicing Mode, If No Access Code Is Being Used - Ecolab EcoAdd Manuel D'utilisation

Servicing
11.1.1

Shift the pump to servicing mode, if no access code is being used

7
Fig. 90: Shift the pump to servicing mode, if no access code is being used
Put the pump into servicing mode:
1.
On the operating screen, press the servicing symbol ( ,
2. If the [access code] is not active
servicing?'
3. Cancel maintenance: Press the cancel button
ð The query screen is closed, service mode has not been started and the operating
screen is displayed.
4.
Start maintenance: Press the OK button
ð The pump then puts the motor and the diaphragm into service position.
5. A prompt screen 'Servicing: Switch off the pump!' appears.
6. The pump is switched on and off via the 'ON/OFF button'
7. Carry out servicing!
8. After restarting the pump, a query screen 'Is the servicing done?' is shown.
9. Do not confirm the servicing: Press the cancel button
10. Main screen 'Servicing not done!' is displayed.
The internal counter for the servicing done (
on page 128) is not raised. The operating screen (pos. 13) is displayed after
confirming this note screen and the pump becomes ready for operation.
11. Confirm servicing: Press the OK button
12. Main screen 'Servicing done!' is displayed.
The internal counter for the servicing done (
on page 128) is raised. The operating screen (pos. 13) is displayed after confirming
this note screen and the pump becomes ready for operation.
417102276 Rev. 5-02.2020
2
1
9 11
8
To access the maintenance mode, press and hold the displayed
maintenance signal for around 3 seconds.
3
4
10
, the query screen 'Pump service' / 'Carry out
.
.
Ä Chapter 7.12 'Operating data'
.
Ä Chapter 7.12 'Operating data'
158
6
5
12
13
or ).
.
.