Ecolab EcoAdd Manuel D'utilisation page 361

11.1.2 Put the pump in the maintenance mode when an access code is being used
Fig. 91: Put the pump in the maintenance mode when an access code is being used
Put the pump into servicing mode:
1. On the operating screen, press the servicing symbol ( ,
2.
If the [access code] is activated
3.
Cancel maintenance: Press the cancel button
ð The query screen is closed, service mode has not been started and the operating
screen is displayed.
4.
Start maintenance: Press the OK button
ð The pump then puts the motor and the diaphragm into service position.
5. A prompt screen 'Servicing: Switch off the pump!' appears.
6. The pump is switched on and off via the 'ON/OFF button'
7. Carry out servicing!
8.
As the [access code] is still activated
2
1
2
6
8
7
12
10
9
To access the maintenance mode, press and hold the displayed
maintenance signal for around 3 seconds.
If you have activated an [access code]
Ä Chapter 7.7.2 'Open the main menu with the access code
activated' on page 74.
If you have activated an [access code]
Ä Chapter 7.7.2 'Open the main menu with the access code
activated' on page 74.
3
11
, the [access code] must now be entered.
, note the following:
.
.
, the [access code] must now be re-entered.
, note the following:
159
Servicing
4
5
13
14
or ).
.
417102276 Rev. 5-02.2020