Acknowledge Automatically - Ecolab EcoAdd Manuel D'utilisation

Control / Software

7.10.8.1 Acknowledge automatically:

The pump switches to Pause on empty signal and the empty signal symbol is displayed in
red . The suction pipe issues a "Full" signal to the pump after a container change and
the container change is detected and accepted without further confirmation.
Fig. 56: Acknowledge automatically
[Acknowledge automatically] - setting:
1. [Call up the Main menu] :
2. [Configuration] - setting:
3. Use the scrollbar to scroll to the [Empty signal] .
4. [Select Empty signal] .
5. If required, select 'Empty signal contact' : 'Closed contact = Empty signal' .
ð After selecting this, a check mark
6. [ Click Next]
ð Screen changes to the acknowledgement query of the 'empty signal' .
7. [Acknowledge automatically] .
8.
Pressing the
ð The screen switches to the overview: [Configuration].
9. By pressing the
10. By pressing the
417102276 Rev. 5-02.2020
3
5
4
Ä Chapter 7.7 'Main menu' on page 73
Ä Chapter 7.10 'Overview - Configuration' on page 92
to save the setting.
button saves the setting.
button, you can return to the [main menu].
button, you can return to the [operating display].
104
6
is set in the selection field.
8
7