Diaphragm Breakage - Ecolab EcoAdd Manuel D'utilisation

Control / Software
Fig. 72: Configuration: Max. metering phase
[Select Max. metering phase] :
1. [Call up the Main menu] :
2. [Select Configuration] :
3. Use the scrollbar to scroll to the [Oval gear meter] menu item.
4. [Select Oval gear meter] .
ð Screen switches to the [selection Oval gear meter].
5. [Select Max. metering phase] .
ð Screen change for the setting: [Max. metering phase]
6. Enter the seconds before the decimal point with the scrollbar.
7. Select the seconds after the decimal point.
8. Enter the seconds with the scrollbar.
9.
Press the
ð The setting is saved, and the screen switches back to the menu
[Oval gear meter] .
10. Press the
ð The setting is saved, and the screen switches back to the configuration overview.
11. By pressing the
12. By pressing the

7.10.15 Diaphragm breakage

Under 'diaphragm breakage' the monitoring of the pump diaphragm is switched on or off.
Requirements:
n This function can only be used when a pump head of 30 l/h, 50 l/h or 120 l/h size is
installed on the pump with the respective diaphragm protection sensor.
n Select the corresponding sensor for diaphragm breakage
head 30 l/h and 50 l/h' on page 173, pos. 9 or
on page 174, pos. 11 and install.
Electric connection - Sensor for diaphragm breakage
417102276 Rev. 5-02.2020
3
4
Ä Chapter 7.7 'Main menu' on page 73
Ä Chapter 7.10 'Overview - Configuration' on page 92
button.
button.
button, you can return to the [main menu].
button, you can return to the [operating display].
The electric connection is done on the main board
Ä Chapter 6.4.7 '[Diaphragm] Diaphragm breakage monitoring ' on page 59
The connections are as follows:
14 = GND
15 = Diaphragm
16 = 5 Volt
17 = Anode
5
6
Ä Chapter 12.2.5 'Pump head 120 l/h'
124
9
7
8
Ä Chapter 12.2.4 'Pump