Stryker SMRT Power System 6500 Manuel D'utilisation Et D'entretien page 33

CLEANING THE BATTERY (CONTINUED)
To clean the SMRT Pak:
1. Remove the SMRT Pak from the Power-PRO cot
or SMRT Charger.
2. Inspect the SMRT Pak housing for any cracks
or damage.
3. Clean the SMRT Pak with a hospital grade
disinfectant with a pH range of 6.5 to 10.5. See
the Recommended Cleaners list on
WARNING
• To reduce the risk of injury, do not directly handle or make contact with the
SMRT Pak terminals while cleaning.
• Use only non-conductive materials to wipe the SMRT Pak clean.
4. Rinse the SMRT Pak thoroughly with clean water to remove any cleaning
chemicals or residue. Position the SMRT Pak as shown in Figure 11 to avoid
water from pooling near the terminals.
WARNING
• To reduce the risk of injury, do not directly handle or make contact with the
SMRT Pak terminals while rinsing.
• Avoid excessive water exposure to the SMRT Pak terminals.
5. Dry thoroughly before inserting the SMRT Pak into a Power-PRO cot or
SMRT Charger.
WARNING
• To reduce the risk of electric shock, do not immerse the SMRT Pak in liquid.
• Do not use solvents, lubricants, or other chemicals to clean the SMRT Pak
unless otherwise directed.
• Refer to the disinfectant's Material Safety Data Sheet (MSDS) to verify the
pH range. Disinfectants with pH levels higher than 10.5 may cause the SMRT
Pak housing material to crack.
www.stryker.com
Cleaning
page 1-25.
6500-109-105 REV A
Figure 11: SMRT
Pak
Return To Table of Contents
1-27
English