Summary Of Safety Precautions - Stryker SMRT Power System 6500 Manuel D'utilisation Et D'entretien

Carefully read and strictly follow the warnings and cautions listed on these pages.
English
Service only by qualified personnel.
WARNING
• When charging a SMRT Pak in an ambulance, locate the SMRT Charger in
an enclosed cabinet and out of patient reach during transport.
• To comply with established ambulance crash test standards, mount the
SMRT Charger to the optional mounting bracket in an enclosed cabinet and
out of patient reach during transport.
• For ambulance installation, a certified mechanic that is familiar with
ambulance requirements should install the optional mounting bracket and
the SMRT Charger. Improper SMRT Charger installation may cause injury to
the patient or operator and/or damage to the SMRT Charger or SMRT Pak.
• Ensure that the mounting bracket is securely attached to the surface.
• If the SMRT Pak is cracked or damaged, do not insert it into the SMRT
Charger. Return damaged SMRT Paks to a service center for recycling.
• To reduce the risk of electric shock, do not remove the SMRT Pak when the
Power-PRO cot is activated.
• Always wear rubber gloves when cleaning the SMRT Charger to reduce the
risk of injury.
• To avoid electrical hazards, always disconnect the SMRT Charger from the
wall outlet before cleaning.
• Do not spray fluid directly onto the SMRT Charger.
• Do not power wash the SMRT Charger.
• To reduce the risk of electric shock, do not immerse the SMRT Charger in
liquid.
• Do not use solvents, lubricants, or other chemicals to clean the SMRT
Charger unless otherwise directed.
• To reduce the risk of electric shock, do not allow water to collect on top of
the SMRT Charger.
• In addition to personal protective equipment (PPE), always wear insulative
rubber gloves when cleaning the SMRT Pak to reduce the risk of injury.
• While power washing, use any appropriate personal safety equipment
(goggles, respirator, etc.) to avoid the risk of inhaling contagion. Use of
power washing equipment can aerate contamination collected during the
use of the cot.
• To reduce the risk of injury, do not directly handle or make contact with the
SMRT Pak terminals while cleaning.
• Use only non-conductive materials to wipe the SMRT Pak clean.
Return To Table of Contents
1-10

Summary of Safety Precautions

6500-109-105 REV A www.stryker.com