Stryker SMRT Power System 6500 Manuel D'utilisation Et D'entretien page 18

English
WARNING (CONTINUED)
• Inspect SMRT Paks for damage before every use. Do not charge or use if
there is any evidence of damage. During cleaning, moisture may enter a
cracked housing and damage the electrical components or cause leaking
or venting of battery electrolyte. This may result in chemical burns of skin
and eyes.
• Never incinerate the SMRT Pak, even if it is severely damaged, because the
SMRT Pak can explode in a fire.
• Never short-circuit the SMRT Pak by connecting the terminals with any
conductive material.
CAUTION
• Only use the SMRT Pak and SMRT Charger as specified.
• Place the electrical power cord where it will not be stepped on, tripped over,
or otherwise subjected to damage or stress.
• Do not touch the SMRT Pak receptacle terminals with metal objects.
• To reduce the risk of damage to the electrical plug and cord, grasp and pull
the plug, not the cord when disconnecting the SMRT Charger.
• Make sure that the SMRT Pak is fully charged prior to placing into service.
An uncharged or depleted SMRT Pak may cause poor cot performance.
• Remove the SMRT Pak if the Power-PRO cot is not going to be used for an
extended period of time (over 1 week).
• Remove the SMRT Pak before washing the Power-PRO cot. See
for cleaning instructions.
• Dry the SMRT Paks before placing them in the SMRT Charger to avoid
damage to the batteries or charger.
• Replace a SMRT Pak in the Power-PRO cot at the first indication that it is
losing power. Using a SMRT Pak until it is completely drained may cause
permanent damage and will shorten the life and output of the SMRT Pak.
NOTE
• The cot indicator LED does not have to flash amber before removing and
charging the SMRT Pak, however this is considered to be a "best practice."
• For extended storage, the SMRT Pak should remain on the SMRT Charger
to trickle charge and ensure that the SMRT Pak remains fully charged. The
SMRT Charger keeps the SMRT Pak charged and ready for use.
• To maximize available battery power, only use SMRT Paks that have been
fully charged within the last 48 hours.
• Fully charge the SMRT Pak for two hours before troubleshooting the Pak.
Return To Table of Contents
1-12
Summary of Safety Precautions
6500-109-105 REV A
page 1-25
www.stryker.com