Smrt Charger Troubleshooting - Stryker SMRT Power System 6500 Manuel D'utilisation Et D'entretien

SMRT CHARGER TROUBLESHOOTING

Problem/Failure Recommended Action
SMRT Charger
power LED is
not illuminated
SMRT Charger
will not charge
the Pak
www.stryker.com
Troubleshooting
1. Verify that the AC power supply or DC cable is
connected properly.
A. If using an AC power supply, make sure that the:
a. AC power cord is plugged into a wall outlet and
the wall outlet has AC power.
b. AC power cord is plugged into the power supply.
c. AC power supply output cord is plugged into the
charger.
B. If using a DC cable, make sure that the:
a. DC cable is plugged into a power source with
12.5 - 16 VDC.
Note: The DC power supply output cord
adaptor LED should be illuminated.
b. Power cord adaptor internal fuse has continuity.
If not, replace the fuse (see
c. DC cable is plugged into the charger.
2. Check for 12.5 - 16 VDC at the power supply output
cord that plugs into the charger.
A. If 12.5 - 16 VDC is not present, replace the power
supply assembly.
B. If 12.5 - 16 VDC is present, replace the charger.
1. Verify that the charger power LED is illuminated.
A. If not, see the "SMRT Charger power LED is not
illuminated" section.
2. Verify that the charger indicator LEDs flash when the
charger is first powered.
A. If the LEDs flash at start up, go to step 3.
B. If the LEDs do not flash at start up, replace the
charger.
3. Reinsert the Pak on the charger and check the charger
indicator LEDs for the status of the Pak:
A. Solid amber = a Pak error. See Pak Troubleshooting
on page 1-31.
B. Flashing amber = a temperature delay. Allow the
Pak time to get to normal operating temperature.
Reinstall the Pak and recheck step 3.
C. Solid green = See Pak Troubleshooting on
page 1-31.
6500-109-105 REV A
page 1-33).
Return To Table of Contents
1-29
English