Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Uncrating Cart
1. Remove paddle from skid by cutting plastic straps.
2. Cut strap holding front axle to skid.
3. Remove wheel chocks from skid at handle end of
cart.
4. Roll cart(s) out of base section.
5. Remove tape holding lid to cart.
6. Remove lid storage bracket(s) from inside cart.
(Brackets may be installed on left or right side of bin.
See Installing Bin section.)
Uncrating and Installing Base Section
1. Remove screws holding flanged feet and tie-down
straps to skid and remove skid.
2. Remove packing material from inside of legs and
around shutter door.
3. Position base in intended position and adjust feet to
level unit in both directions.
4. Mark position of each flanged foot anchoring hole.
5. Move base out of way and install anchors for 1/4"
bolts in floor (supplied by others).
6. Reposition unit in intended position and anchor base
unit to floor through flanged feet.
!
When leveling, do not extend any leg more than 1"
(26 mm) for total leg height no greater than 2.125"
(54 mm). Legs must be secured to floor through feet
to avoid possible movement and resulting injury.
Installing Bin
1. Remove 4 bolts fastening skid to underside of bin.
2. Remove all protective wrap from exterior.
3. Run 1/8" bead of supplied silastic in center of each
gasket band on base.
4. Install bin section on base section, taking care that
locating pins in base engage holes in bin.
4
Installation Instructions
Warning
Section 2
LOCATING PIN
BEAD OF
SILASTIC
GASKET
5. Use fasteners provided to install paddle support
bracket on right or left side of bin in holes provided.
6. Remove paper from back of cart lid storage
bracket(s) and position brackets on side of bin.
7. Remove all tape and temporary fastenings from
door assemblies and outside of bin.
8. Mount ice machine(s) on top of bin in accordance
with ice machine instructions.
9. Install tie-down straps.
Installing Tie-down Straps
Tie-down straps to secure bin to base are provided
on each side of unit. Straps must be installed to
avoid possible injury should unit move. Bolt unit to
wall for increased stability, and bolt to floor to
prevent side-to-side movement.
1. Remove screws from rivnuts on each side of bin
section.
2. Reposition tie-down strap up until slot matches
rivnut opening.
3. Reinstall screws in rivnuts and tighten.
BIN
SECTION
BEAD OF
SILASTIC
GASKET
BASE
SECTION
!
Warning
Part Number 000006529 10/09
Publicité
Chapitres
Table des Matières
